search

Connect-tech PCI-104 Uživatelský manuál Strana 19

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 39
  • Tabulka s obsahem
  • KNIHY
    • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 18
Connect Tech FreeForm/PCI-104 User Manual
Revision 0.02 19
FPGA Configuration
The Virtex-5 FPGA can be configured via two methods:
o JTAG programming chain, using P2
o SPI Flash, read on, power-up by FPGA
The configuration flash can be programmed (loaded) through three methods:
o JTAG programming chain (through FPGA), using P2
o Direct with cable, using P3
o Indirect programming through FPGA, only possible after configuration is complete (refer
to reference design for more details)
To configure the FPGA via the JTAG / boundary scan programming chain, three items are required:
o FPGA bitstream (*.bit), generated at end FPGA implementation using ISE
o PLX 9056 boundary scan definition file (*.bdsl)
o Ethernet PHY boundary scan definition file
To program the SPI flash, a hex file must be generated (*.mcs) then written to the flash. To generate
the hex file, the following is required:
o FPGA Bitstream
o Setting PROM file format to MCS (important since bits are swapped)
o Setting SPI PROM density to 16M
o Setting SPI Flash type to M25P16
For a complete procedure, refer to Appendix A.
Zobrazit stránku 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

Komentáře k této Příručce

Žádné komentáře
  • Prima Appliance Care ProFlow ADLY MOTO Cal Amp Beyma
  • Kenmore Elite Sporáky Akai Budíky Philips Bezpečnostní kamery Rinnai ne Kenwood Navigační systémy pro automobily
  • Cello SERAFIN AEG AHB52111LW Acer AT1927ML Acer V233HL Samsung UW21J10VD
  • Sony KDL-32WD757 Uživatelský manuál Acer B276HL Uživatelský manuál SilverStone ST65ZF Manuál Medion AKOYA Uživatelský manuál