Connect Tech Echo/ISA Uživatelská příručka stáhnout pdf (Strana 13)

MultiModem ZPX User Guide 13

4. Place the MultiModem ZPX directlyabove theexpansion slot and gently, but firmly, push it into

the connector until the card’s retainingbracket is flush against the computer chassis.

5. Fasten the retaining bracket to the computer chassis with the screw saved inStep 3.

6. Replace the cover of the computer.

Step 4 - Run Add Hardware Wizard

1. Click Start I Control Panel and double-click Add Hardware to open the Add Hardware Wizard.

2. Click Next. The wizard will pause a few seconds trying to detect the new device. Windows will

not detect any device, if the system does, it may be some other device that has not been

properly installed.

3. Select Yes, I have already connected the hardware and click Next.

4. Scroll to the bottom of the list and select Add a new hardware device. Click Next.

5. Select Install the hardware that I manually select from a list [Advanced] and click Next.

6. Scroll down and select Ports [COM & LPT]. Click Next.

7. Select Communications Port under Model and click Next twice.

8. Click View or change resources for this hardware [Advance] to open the Add Hardware

Wizard Properties window.

9. Click Set Configuration Manually and click OK.

10. Select a Basic configuration ### option from the Setting based on drop-down list. When you

select a basic configuration, the details appear in the Resource settings field and hardware

conflicts appear in the Conflicting device list field. For example Basic configuration 0003 has

an I/O range 02F8-02FF used by Communications Port [COM2].

11. To change either of the settings, click either I/O Range or IRQ in the Resource type field and

then click Change Setting.

• If you change the I/O Range, click the up or down arrow to select a range in the Value

field and click OK.

• If you change IRQ, click the up or down arrow for the Value field to select the interrupt

value that you recorded earlier. Click OK.

12. Click Finish. A prompt to restart Windows appears. Click Yes to restart.

13. After the system reboots, verify that your com port is available and your IRQ is correct. Click

Start |Control Panel and double-click System. Then, click the Hardware tab.

14. Click Device Manager. Click Ports (COM & LPT) to display the Communications Ports. If either a

yellow Exclamation point or Red Question mark appears, there is either a conflict with another

resource or that the device is disabled. If there are no yellow exclamation points or red question

marks, there are no conflicts.

Chapter 2 - Installation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Žádné komentáře

Connect Tech Echo/ISA Uživatelská příručka Strana 13